IPI Instrumentation

AST50/AST60

These sensors are designed for use in general purpose applications up to about 50,000 microsiemens, and provide outstanding chemical resistance. Open front end geometry resists clogging and reduces maintenance requirements to a minimum.

AST52

This sensor has a small footprint for its high cell constant of 10.0. Its size and economical pricing make it ideal for use ins OEM applications, such as skid mounted R.O. systems, water treatment units, chemical dilutions, and many more.

AST10 and AST51

The AST10 and 51 sensors offer a compact design that allows installation into standard pipe fittings in small line sizes such as 3/4″ and 1″, avoiding the need for special flow cells. Simplicity of the design also allows them to be economically offered in exotic metals for especially corrosive chemical applications.

ASTXX-TRI

The AST10, AST51 and AST52 sensors are welded to blind flanges of customer specified size, and can then be inserted into standard tee fittings in sanitary systems using fittings by Ladish or Alfa-Laval Tri-Clover.

AST41

The Model AST41 sensor was designed for high pressure, high temperature conductivity measurements, and is an ideal choice for boiler control applications. Blowdown control, condensate monitoring, leak detection on heat exchangers, and steam purity measurements are just a few of the many applications in which this rugged and reliable sensor can be used.

AST40 and AST42

The Model AST40 sensor has been designed for a wide measurement range in difficult process conditions. It can be installed in submersion, insertion, or wet-tap configurations, and is good for most applications from high purity water to high chemical concentrations.

ISE Sensors

Industrial Ion Selective Electrodes (ISE) Sensors for all industrial waste-monitoring applications. Used to check the treatment levels.